Spoon Twin-block Brake Caliper (45020-DCR-G00) on EG6: update on Slipstreams Fit
Update: I tested fit with a 7" width with +40 offset slipstreams. As calculated, the clearance from the calipers is 3mm (2.5mm from the "Spoon" lettering).
Oh thank you!! I have Rota Slipstreams 15x7 Offset 40 and i'm going to put the spoon twin block calipers. But i have this problem, the spoon calipers are meant for 282x23mm discs as the ek9 has, my discs are 282x25 from a MG ZR 160 4x100. What mods i'll need to fit the spoon calipers??
In this setup with 7" rims and 40 offset what spacers do you have??
ReplyDeleteIn this setup with 15x7" Rota Slipstream Offset 40 what spacers do you have for the 3mm clearance???
ReplyDeleteI have a 3mm spacer between the brake disc and the hub as required by the installation of the Spoon Caliper. (Not between the wheel and brake disc).
ReplyDeleteYes, it is a 15inch. As long as the ROTA are 7inch width with 40 offset. It will have 3mm clearance. The diameter of the rims will not matter.
Oh thank you!! I have Rota Slipstreams 15x7 Offset 40 and i'm going to put the spoon twin block calipers. But i have this problem, the spoon calipers are meant for 282x23mm discs as the ek9 has, my discs are 282x25 from a MG ZR 160 4x100. What mods i'll need to fit the spoon calipers??
ReplyDeleteYou will need the 3mm spacer to be placed between the hub and the disc to center the brake disc to the calipers.
ReplyDeleteAlso watch where you place the washer for the bolt.
As the disc thickness, u might need to sand down the brake pads to have it fit.
http://honda-eg6.blogspot.com/2012/01/spoon-twin-block-brake-caliper-45020.html
ReplyDeleteThanks i'll buy some 3mm spacers cheers!
ReplyDelete